Loader options can be set by
selecting the OPTIONS menu item, located on the main menu bar.
Program Code
Optionally program user code
when writing to the target microcontroller. Uncheck this option
to prevent user code from being programmed. The default is ON.
Program Data
Optionally program EEPROM data
when writing to the target microcontroller. Uncheck this option
to prevent EEPROM data from being programmed. The default is
ON.
Verify Code
Optionally verify user code when
verifying the loaded *.hex file. Uncheck this option to prevent
user code from being verified. The default is ON.
Verify Data
Optionally verify EEPROM data
when verifying the loaded *.hex file. Uncheck this option to
prevent EEPROM data from being verified. The default is ON.
Verify After Programming
Performs an additional verification
operation immediately after the target microcontroller has been
programmed. The default is OFF.
Run User Code After Programming
Exit the bootloader process immediately
after programming and then start running the target user code.
The default is ON.
Load File Before Programming
Optionally load the latest version
of the *.hex file immediately before programming the target microcontroller.
The default is OFF.
Baud
Rate
Select the speed at which the
computer communicates with the target microcontroller. By default,
the Auto Detect option is enabled. This feature enables MicroCode
Loader to determine the speed of the target microcontroller and
set the best communication speed for that device. If you select
one of the baud rates manually, it must match the baud rate of
the loader software programmed onto the target microcontroller.
For devices running at less that 20MHz, this is 19200 baud. For
devices running at 20MHz, you can select either 19200 or 115200
baud.
See Also
The
Main Toolbar
|