BASCOM LT©

Using an I2C clock device with the PCF8583

This application note shows how to use the PCF8583 I2C clock
It has been tested in the Simulation Hardware mode.

The schematic is very simple since the IC only uses an XTAL and a capacitor

I used a Dontronics DT003 power-board as a basis, and a Dontronics prototypeboard for the PCF8583
With some modifications the DT104 could be used also.

Schematic:

Program:
Download clock.bas source code

Last Up-dated at January 14st, 1998

GRIFO®
Via dell'Artigiano, 8/6
40016 San Giorgio di Piano
Bologna ITALY

Tel: +39 051 892.052 (4 lines)
FAX: +39 051 893.661

Home BASCOM LT Application Cat. Index