CCR Plug 9 is a group of communication cables,
with 1,5 meters length, equipped with a 6 pins Plug
connector on one side and a 9 D pins connector on the
other side.
Their typical use is for RS 232 (but also RS 422, RS 485 and Current
Loop) connections between cards provided of plug connector and
the wide range of commercial serial devices as P.C., modem, terminal,
etc.
This cable is realized with a 6 wires line cord, connected to two male Plug connectors in reversed mode and it performs connection between two cards provided of serial lines on Plug connectors (GPC® xxx, UBC B2, UCC A2, QTP G28, etc).
This cable is realized with a 6 wires line cord, connected to a male Plug connector and one male D9 connector with pin out compatible to QTP xxx. It performs RS 232 connection between one card provided of serial lines on female Plug connector (GPC® xxx, UBC B2, UCC A2, etc) and one of the QTP operator panel provided of female D9 connector (QTP 12, QTP 12/R84, QTP 16, QTP 24, MDU 01, etc.).
This cable is realized with a 6 wires line cord, connected to a male Plug connector and one male D9 connector with pin out compatible to Modem. It performs RS 232 connection between one card provided of serial lines on female Plug connector (GPC® xxx, UBC B2, UCC A2, etc) and a commercial Modem provided of standard female D9 connector, complete of handshake signals connection, necessary for the same Modem management.
This cable is realized with a 6 wires line cord, connected to a male Plug connector and one male D9 connector with standard DTE pin out (the same available on P.C.). It performs RS 232 connection between one card provided of serial lines on female Plug connector (GPC® xxx, UBC B2, UCC A2, etc) and one of the numerous commercial serial devices provided of female D9 connector with DCE standard, or in other words all the devices that can be directly connected to P.C. (bar code reader, terminal, scanner, badge reader, etc.).
This cable is realized with a 6 wires line cord, connected to a male Plug connector and one male D9 connector with pin out compatible to P.C. together with grifo® software development tools (GDOS xxx., FGDOS xxx, FMO 52, NO ICE xx, etc.). It performs RS 232 connection between one card provided of serial lines on female Plug connector (GPC® xxx, UBC B2, UCC A2, etc) and a standard male D9 connector connected to COMx of the development P.C. that runs the proper communication programs as GET xxx, Terminal of BASCOM, HYPERTERMINAL, etc.
Page up-dated at January 07, 2004
GRIFO®
Via dell'Artigiano, 8/6
40016 San Giorgio di Piano
Bologna ITALY
Tel: +39 051 892.052 (4 lines)
FAX: +39 051 893.661
