CAN GMT

Controller Area Network - grifo® Mini Module Test

CAN GMT English Tech. Manual PDF format.

Ver. 5.10 - Rel. 25 June 2002.

Image above shows CAN GMT designed to install modules with DIP 28 size.

The test board CAN GMT has been developed to provide a comfortable and fast environment for MiniModules type CAN GM0, CAN GM1, CAN GM2, etc.

These Mini Modules, with dimensions similar to a standard 28 pins DIP integrated circuit, include a complete and efficient CPU board.

The most important features of CAN GMT are:

• - 28 pin dual in line female socket (100 mils pitch, 600 mils width) capable to accomodate the modules type CAN GM Zero, CAN GM1, CAN GM2, etc
• - Standard jack 2,1 mm power supply connector.
• - Power supply section that accept an input voltage in the range 7÷12V AC or DC, compatible with the greater part of low cost main adaptors.
• - LED on +5 Vdc voltage, generated by power supply section.
• - RESET push button.
• - Buzzer for acoustic signal driven by CAN GMx module or by external signal.
• - LED that shows status of real time clock /INT output signal on CAN GMx module.
• - Screw driver connector with I2C BUS signals of CAN GMx module.
• - DB9 female connector with RS 232 serial line of CAN GMx module.
• - DB9 male connector with CAN line of CAN GMx module (standard CIA: DS102).
• - 16 TTL I/O lines of CAN GMx module are connected to a low profile 20 pins connector with standard pin outs that can be used to directly manage the numerous grifo® cards.
• - Jumper for connection of 120 ohm termination resistor, on CAN line.
• - 6 push buttons, 6 jumpers and 6 LEDs suitable for setting, forcing and display the status of 6 TTL I/O lines of CAN GMx module.
• - Three colours LEDs (Red, Yellow, Green) to discriminate their functionality.
• - Pod and jumper for A/D Reference Voltage connection of CAN GMx module.
• - Wide prototype area, double sided with metallized holes, surrounded of pods that bring all the module signals and respective names.
• - Two mounting possibility: layed on a plane surface through 4 rubber supports or bolt on each surfaces through 4 support holes, placed on the corner of the board.
• - Small dimension: 100 x 120 x 30 mm.

Image above shows CAN GMT designed to install modules with DIP 28 size.

| CAN GM Zero | | CAN GM1 | | CAN GM2 | | CAN GMT | | CAN PIC | | CAN AVR |

Page up-dated at December 04, 2004

GRIFO®
Via dell'Artigiano, 8/6
40016 San Giorgio di Piano
Bologna ITALY

Tel: +39 051 892.052 (4 lines)
FAX: +39 051 893.661

Home Software Utility Tables Cat. Index Es. BAS. K51